Description
Included in this kit
This bundle includes 2x Clarion CMSP-771RGB-SWG Premium 7.7-inch Coaxial Marine Speakers with built-in RGB illumination, 60W RMS, with White & Gray Metallic Grilles, and a Clarion CMR-L1 Marine LED Light Controller.
2x Clarion CMSP-771RGB-SWG Premium 7.7-inch Coaxial Marine Speakers with built-in RGB illumination, 60W RMS, with White & Gray Metallic Grilles - (CMSP-771RGB-SWG)
7.7-inch woofer delivers more output and stronger bass, compared to the 6.5-inch model.
Includes White & Gray Metallic Sport Grilles
Salt & Sun Certified
Built-In RGB LED Lighting
Waterproof Connectors for Speaker & LED Illumination
60W RMS power handling, ideally matched to Clarion Marine amplifiers
Bridge-mounted, 1-inch (25 mm), edge-driven, silk dome tweeter with neodymium magnet and ferrofluid cooling
1x Clarion CMR-L1 Marine LED Light Controller - (CMR-L1)
The Clarion CMR-L1 Marine LED light controller adds some flair to Clarion and other RGB LED marine speakers!
Specifications:
• Dynamic Modes 20
• Dynamic Speed Levels 10
• Static Colors 20
• Direct Preset Colors 7
• Brightness Levels 8
• Operating Voltage 10- 15V DC
• Operating Temp Range -4 ° F to + 1 58 ° F, (-20 °C to + 70 °C)
• Operating Frequency 433.92 MHz
• Operating Range* Up to 15 m (49.2 ft)
• Output Capacity 2 A (maximum)
• Recommended Fuse Value 10 A (maximum)
• Transmitter Battery CR2025 (3V)
• Dimensions 2. 99 in x 2 in x 1 .07 in
• (Transmitter) 76 mm x 50.8 mm x 27.2 mm
• Dimensions 4.02 in x 3.01 in x 1.42 in
• (Receiver) 102.1 mm x 76.5 mm x 36.1 mm
Notes:
• Install in a dry, well-ventilated location; do not install in an engine compartment or other areas of extreme heat. Do not install where it will be directly exposed to the elements.
• To optimize performance, avoid confined installation locations or areas surrounded by metal; maintain at least 25 cm (10 in) of separation from any audio signal cables.
• Make sure the total amperage demands of all connected LED circuits does not exceed the output capacity of the controller.
• *Install a fuse (not included) at the main +12V power wire (Red) connection point that is appropriate for the total current draw of all LED circuits (up to 10 A).
• For short-circuit protection, we recommend installing a fuse (not included) at EACH speaker's +12V LED connection lead. Refer to your speaker's LED specifications for individual fuse values.