Description
Included in this kit
This bundle includes a JL Audio XDM400/4 XDM Series 4-Channel Class-D Full Range Car/Marine Amplifier, 400 W, a JL Audio MM105 - MediaMaster IP67 Weatherproof 4-Zone Premium Source Unit with Full-Color LCD Display, 12-Channel 4-Volt Preamp Outputs, a Clarion CMR-L1 Marine LED Light Controller, and 2x JL Audio 7.7-Inch M6 Marine Coaxial Speaker System, RGB LED, Gunmetal & Titanium, Sport Grille - SKU: M6-770X-S-GmTi-i.
1x JL Audio XDM400/4 XDM Series 4-Channel Class-D Full Range Car/Marine Amplifier, 400 W - (XDM400/4)
JL Audio XDM400/4 4-Channel Class D Full-Range Car/Marine Amplifier, 100 W x 4 @ 2 Ī© / 75 W x 4 @ 4 Ī© - 14.4V
The ultra-compact XDM400/4 packs a serious full-range punch, generating a whopping 100 watts to each of its four channels into 2 ohms (14.4V, 1% THD). The technology that makes this much power possible in such a compact chassis is JL Audio's advanced NexDā¢ high-speed switching design, which permits full bandwidth Class D operation with extremely low distortion and remarkable efficiency.
Suitable for car or boat installations, the XDM400/4 is built with marine-grade materials and features an exclusive, dual-mode input filter for noise-free performance in boats or cars. Automatic turn-on capability (via signal sensing or DC-offset sensing) is also onboard for easy factory system upgrades.
Combine the XDM400/4 with JL Audio's XDM600/1 monoblock to build a stunning 1000 W amplification system to power four satellites and a subwoofer... and fit the whole thing under a seat or deck. Or, use the XDM400/4 by itself to power two satellites, plus a subwoofer.
The XDM400/4 includes a 12 dB / octave filter for each channel bank, which can be configured as a low-pass or high-pass filter and offers continuously variable cutoff frequency selection from 50-500 Hz. With the addition of an optional HD-RLC or MHD-RLC (water-resistant) remote level controller (each sold separately), you have the ability to adjust the level of all amplifier channels or just the rear channels directly from the driver's seat or cockpit.
Finished in a sleek, black powder-coat, all controls are protected beneath a gasketed, removable top cover for easy access.
Specifications
Rated Continuous (RMS) Power @ 14.4 V
@ 4 Ī© | 75 W RMS x 4 |
@ 2 Ī© | 100 W RMS x 4 |
Bridged @ 4Ī© | 200 W RMS x 2 |
Rated Continuous (RMS) Power @ 12.5 V
@ 4 Ī© | 60 W RMS x 4 |
@ 2 Ī© | 90 W RMS x 4 |
Bridged @ 4Ī© | 180 W RMS x 2 |
General Specifications
Frequency Response | 12 Hz - 22 kHz (+0, -1dB) |
S/N Ratio, referred to highest rated power | >104 dB below rated power (A-weighted, 20 Hz - 20 kHz noise bandwidth) |
S/N Ratio, referred to 1 W | >84 dB (A-weighted, 20 Hz - 20 kHz noise bandwidth) |
Damping Factor @ 4 Ī© | >150 / 50 Hz |
Damping Factor @ 2 Ī© | >75 / 50 Hz |
THD+N @ Rated Power | <1% @ 2 Ī© per Ch. |
Input Voltage Range @ RCA Inputs | 200 mV - 4 V RMS |
Min.Copper Power / Ground Wire Gauge | 4 AWG wire |
Fuse Rating | 40 A (AFS, AGU or MaxiFuseā¢) |
Signal Processing
Filter Mode(s) | Low-Pass or High-Pass |
Filter Slope(s) | 12 dB/octave |
Filter Frequency Range | 50 Hz - 500 Hz |
Detented, Calibrated Filter Freq. Potentiometers | Yes |
Filter Defeat Function | Yes |
Remote Level Control | Optional HD-RLC or MHD-RLC (water-resistant) |
Remote Level Modes | 2 or All channels |
Channel Input Mode Switch | Yes (2/4 ch.) |
Pass-Through Preamp Output | Buffered |
Source Channel Selection for PreOuts | Yes |
Physical Specifications
Height (H) | 2.05 in / 52 mm |
Width (W) | 8.52 in / 216 mm |
Depth (D) | 7.09 in / 180 mm |
Net Weight | 6.3 lb / 2.86 kg |
1x JL Audio MM105 - MediaMaster IP67 Weatherproof 4-Zone Premium Source Unit with Full-Color LCD Display, 12-Channel 4-Volt Preamp Outputs - (MM105)
Enjoy great audio wherever your adventures might take you, with the MediaMaster 105, a Premium Source Unit designed to withstand anything Mother Nature can dish out. This full-featured source unit delivers top-flight sound performance and advanced audio features specifically designed for marine and powersports applications. Its rugged, weatherproof (IP67 rated) chassis houses an ultra-bright, 3.5-inch full-color LCD display, with separate Day/Night lighting themes for outstanding visibility, even in bright sunshine. When in motion, you will also appreciate the clean user interface with big text and large backlit controls.
Because sound quality is our top priority, the MM105 is not equipped with an with an internal amplifier designed to drive loudspeakers directly. Instead , it offers twelve channels of audiophile-quality, preamp level outputs to deliver crystal-clear signals to high quality marine amplifiers. These are deployed via four configurable, nameable audio zones, each with its own set of independent control options, making the MM105 adaptable to a wide range of system types. On-the-fly, level controls make adjusting each or all audio zones a breeze, while a useful volume limit feature ensures that nobody gets blasted inadvertently. All zones feature our Zero-Clipping audio circuit design, with self-limiting tone controls to keep the audio clean at high listening levels, reducing the likelihood of speaker damage.
General Specifications -
ā¢ Input Operating Voltage: 10 - 15.9 VDC
ā¢ Standby Current Draw: 120 mA
ā¢ Operating Current Draw: 1.5A
ā¢ Recommended Fuse Value: 5A
ā¢ Remote Turn-On Capacity: 500 mA (max)
ā¢ Operating Temperature Range: -4F to +158F (-20C to +70C)
ā¢ Display Size/Type: 3.5-inch / TFT LCD backlighted
ā¢ Display Resolution: 320 x 480
ā¢ Output Channels: One stereo pair and mono subwoofer RCA plugs per zone
ā¢ Output Zones: Relative, Absolute, Fixed or Off
ā¢ Maximum Output Voltage: 4V RMS (Relative or Absolute), Selectable 4V/2V/1V RMS (Fixed)
1x Clarion CMR-L1 Marine LED Light Controller - (CMR-L1)
The Clarion CMR-L1 Marine LED light controller adds some flair to Clarion and other RGB LED marine speakers!
Specifications:
ā¢ Dynamic Modes 20
ā¢ Dynamic Speed Levels 10
ā¢ Static Colors 20
ā¢ Direct Preset Colors 7
ā¢ Brightness Levels 8
ā¢ Operating Voltage 10- 15V DC
ā¢ Operating Temp Range -4 Ā° F to + 1 58 Ā° F, (-20 Ā°C to + 70 Ā°C)
ā¢ Operating Frequency 433.92 MHz
ā¢ Operating Range* Up to 15 m (49.2 ft)
ā¢ Output Capacity 2 A (maximum)
ā¢ Recommended Fuse Value 10 A (maximum)
ā¢ Transmitter Battery CR2025 (3V)
ā¢ Dimensions 2. 99 in x 2 in x 1 .07 in
ā¢ (Transmitter) 76 mm x 50.8 mm x 27.2 mm
ā¢ Dimensions 4.02 in x 3.01 in x 1.42 in
ā¢ (Receiver) 102.1 mm x 76.5 mm x 36.1 mm
Notes:
ā¢ Install in a dry, well-ventilated location; do not install in an engine compartment or other areas of extreme heat. Do not install where it will be directly exposed to the elements.
ā¢ To optimize performance, avoid confined installation locations or areas surrounded by metal; maintain at least 25 cm (10 in) of separation from any audio signal cables.
ā¢ Make sure the total amperage demands of all connected LED circuits does not exceed the output capacity of the controller.
ā¢ *Install a fuse (not included) at the main +12V power wire (Red) connection point that is appropriate for the total current draw of all LED circuits (up to 10 A).
ā¢ For short-circuit protection, we recommend installing a fuse (not included) at EACH speaker's +12V LED connection lead. Refer to your speaker's LED specifications for individual fuse values.
2x JL Audio 7.7-Inch M6 Marine Coaxial Speaker System, RGB LED, Gunmetal & Titanium, Sport Grille - SKU: M6-770X-S-GmTi-i - (M6-770X-S-GmTi-i)
JL Audio M6-770X-S-GmTi-i
JL Audio 7.7-Inch M6 Marine Coaxial Speaker System, RGB LED, Gunmetal & Titanium, Sport Grille - SKU: M6-770X-S-GmTi-i
M6 Loudspeakers fulfill JL Audioās commitment to raise the bar with each product generation. The JL Audio engineering team has completely reinvented the premium marine loudspeaker, with major improvements in performance, precision and durability. Offered in multiple sizes and cosmetic options, most models are also available with a brilliant, new lighting technology.
Coaxial Speaker Technology
Every M6 coaxial loudspeaker starts with a long-excursion woofer designed with JL Audioās proprietary motor, suspension and cone modeling systems to yield superior frequency response, smooth mid-range dispersion and linear performance at all listening levels. JL Audioās acoustics laboratory in Miramar, Florida performs extensive testing on multiple generations of prototypes to refine every design and extract maximum performance.
Matching Silk-Dome Tweeters
Since the different size woofers in the M6 coaxials have different upper frequency response limits, each size pairs with its own specially designed, matching silk dome tweeter (0.8, 1.0, or 1.25-inch diameter). Each of these tweeters is precisely tuned via a rear cavity that optimizes its mid-range extension to seamlessly transition with its matching woofer. The result is smooth, evenly dispersed sound throughout the critical crossover region, making the overall sonic presentation clean and clear.
Advanced Built-In Crossover Networks
Crossover networks are a critical part of the M6 coaxial speakersā acoustic design and are considerably more sophisticated than those used in most marine coaxial speakers. The M6-650X employs a 1st order low-pass and 2nd order high-pass filter, while the M6-770X and M6-880X apply a 2nd order low-pass and 3rd order high-pass filter. Each crossover network also employs an electronic tweeter protection circuitto minimize the possibility of tweeter failure.
The multiple components required inthese crossovers are laid out on a ring-shaped circuit board that is built into each speakerās terminal assembly, ensuring that the crossover is secure and protected from the elements.
Transflectiveā¢ LED Illumination
Optional on most M6 models is JL Audioās Transflectiveā¢ LED technology. By emitting light from multiple LEDs through our specially engineered cone material, this patent-pending breakthrough delivers a beautiful cone illumination effect, with no hot spots or reflections on the cone surface.
Choose from seven fixed lighting colors or control the color and intensity of the lighting actively using a lighting controller accessory (sold separately). Separate 12V wiring is required to power the illumination.
General Specifications
Mounting Application | Infinite Baffle |
Continuous Power Handling (RMS) | 100 W |
Recommended Amplifier Power (RMS) | 40 - 200 W / Ch. |
System Efficiency | 91 dB @ 1 W / 1 m |
System Nominal Impedance | 4 Ī© |
System Frequency Response | 45 Hz - 25 KHz Ā± 3 dB |
Coaxial Physical Specifications
Frame Outer Diameter (A) | 7.70 in / 196 mm |
Bolt Hole Circle Diameter (B) | 6.92 in / 176 mm |
Frontal Grille Protrusion | 1.03-Inches for Classic Grille, 1.08-Inches for Sport Grille |
Mounting Hole Diameter (E) | 6.25 in / 159 mm |
Mounting Depth (F) | 3.32 in / 84 mm |