Description
Included in this kit
This bundle includes a Clarion CMR-L1 Marine LED Light Controller, and 2x Clarion CMSP-101RGB-4 10" Marine Subwoofer with RGB LEDs, Single 4-Ohm, 250 Watts.
1x Clarion CMR-L1 Marine LED Light Controller - (CMR-L1)
The Clarion CMR-L1 Marine LED light controller adds some flair to Clarion and other RGB LED marine speakers!
Specifications:
ā¢ Dynamic Modes 20
ā¢ Dynamic Speed Levels 10
ā¢ Static Colors 20
ā¢ Direct Preset Colors 7
ā¢ Brightness Levels 8
ā¢ Operating Voltage 10- 15V DC
ā¢ Operating Temp Range -4 Ā° F to + 1 58 Ā° F, (-20 Ā°C to + 70 Ā°C)
ā¢ Operating Frequency 433.92 MHz
ā¢ Operating Range* Up to 15 m (49.2 ft)
ā¢ Output Capacity 2 A (maximum)
ā¢ Recommended Fuse Value 10 A (maximum)
ā¢ Transmitter Battery CR2025 (3V)
ā¢ Dimensions 2. 99 in x 2 in x 1 .07 in
ā¢ (Transmitter) 76 mm x 50.8 mm x 27.2 mm
ā¢ Dimensions 4.02 in x 3.01 in x 1.42 in
ā¢ (Receiver) 102.1 mm x 76.5 mm x 36.1 mm
Notes:
ā¢ Install in a dry, well-ventilated location; do not install in an engine compartment or other areas of extreme heat. Do not install where it will be directly exposed to the elements.
ā¢ To optimize performance, avoid confined installation locations or areas surrounded by metal; maintain at least 25 cm (10 in) of separation from any audio signal cables.
ā¢ Make sure the total amperage demands of all connected LED circuits does not exceed the output capacity of the controller.
ā¢ *Install a fuse (not included) at the main +12V power wire (Red) connection point that is appropriate for the total current draw of all LED circuits (up to 10 A).
ā¢ For short-circuit protection, we recommend installing a fuse (not included) at EACH speaker's +12V LED connection lead. Refer to your speaker's LED specifications for individual fuse values.
2x Clarion CMSP-101RGB-4 10" Marine Subwoofer with RGB LEDs, Single 4-Ohm, 250 Watts - (CMSP-101RGB-4)
Sold Individually, with no Grille, in single 2 ohm or 4 ohm voice coil models
Salt & Sun Certified
Built-In RGB LED Lighting
Waterproof Connectors for Speaker & LED Illumination
Optimized for infinite baffle applications, without a dedicated enclosure behind the speaker.
Long-excursion, high power handling design delivers low-distortion and excellent low frequency capability.
250W RMS power handling, ideally matched to the Clarion Marine subwoofer amplifier