Included in this kit

---

This bundle includes a JL Audio SB-S-BRZFRS/10TW3: Stealthbox® for 2013-Up Subaru BRZ / Scion FR-S, a JL Audio HD-RLC:Amplifier Remote Level Control and Cable, and a JL Audio XDM300/1 XDM Series Monoblock Class-D Car/Marine Subwoofer Amplifier, 300 W.

1x JL Audio SB-S-BRZFRS/10TW3: Stealthbox® for 2013-Up Subaru BRZ / Scion FR-S - (SB-S-BRZFRS/10TW3)

Somebody finally paid attention and designed a no-nonsense, back-to-basics sports car that puts the emphasis on driving enjoyment. Now all you need to do is add a healthy dose of JL Audio to ratchet up the listening enjoyment and make every drive even more memorable. Our patented 10TW3 thin-line driver is the engine inside this Stealthbox® system, and it produces spectacular results from its perch in the passenger side rear corner of the trunk. Your trunk remains completely useful and your installation is neat and secure. A grille is also included to protect your investment.

The Hard Data: Contains one 10TW3-D4 subwoofer in a sealed enclosure. 400 watt power handling. Wired for 2 ohm mono. Installs in the passenger side of trunk compartment. Black steel mesh woofer grille is included.

1x JL Audio HD-RLC:Amplifier Remote Level Control and Cable - (HD-RLC)

JL Audio HD-RLC: Amplifier Remote Level Control and Cable

Remote Level Control for Select JL Audio Amplifiers

The HD-RLC remotely controls the Bass Level of the following JL Audio amplifiers:

HD-Series: All models

XD-Series: All models

MHD-Series: All models

M-Series: All models

When the HD-RLC is connected to the above amplifiers, it acts as an attenuator on the input gain of the amplifier and is used to adjust the overall level of the amplifier from the front of the vehicle.

The HD-RLC kit includes the rotary control with a black ABS knob, mounting hardware and one 18 ft. (5.5 m) cable.

A satin-finish aluminum knob can be purchased separately.

1x JL Audio XDM300/1 XDM Series Monoblock Class-D Car/Marine Subwoofer Amplifier, 300 W - (XDM300/1)

This little monoblock powerhouse employs our high-speed NexD™ switching design to achieve unprecedented efficiency and amazing power output for its size. It is small enough to fit in most tight space applications, including small boats, pickups, motorcycles and UTV’s (in a weather-tight compartment).

Designed for car or boat installations, the XDM300/1 is built with marine-grade materials and features an exclusive, dual-mode input filter for noise-free performance in boats or cars. Automatic turn-on capability (via signal sensing or DC-offset sensing) is also onboard for easy factory system upgrades.

Targeted specifically for subwoofer applications, the XDM300/1 includes a variable slope low-pass filter with continuously variable cutoff frequency selection from 50-500 Hz. With the addition of an optional HD-RLC or MHD-RLC (water-resistant) remote level controller (each sold separately), the amplifier's level can be adjusted directly from the driver's seat or captain’s chair.

Finished in a sleek, black powder-coat, all controls are protected beneath a gasketed, removable top cover for easy access.

Specificiations:
Rated Continuous (RMS) Power @ 14.4 V
@ 4 Ω: 200 W RMS x 1
@ 3 Ω: 250 W RMS x 1
@ 2 Ω: 300 W RMS x 1
@ 1.5 Ω: N/A

Rated Continuous (RMS) Power @ 12.5 V
@ 4 Ω: 160 W RMS x 1
@ 3 Ω: 210 W RMS x 1
@ 2 Ω: 270 W RMS x 1
@ 1.5 Ω: N/A

General Specifications
Frequency Response: 10 Hz - 1 kHz (+0, -1dB)
S/N Ratio, referred to highest rated power: >100 dB below rated power (A-weighted, 20 Hz - 20 kHz noise bandwidth)
S/N Ratio, referred to 1 W: >80 dB (A-weighted, 20 Hz - 20 kHz noise bandwidth)
Damping Factor @ 4 Ω: >120 / 50 Hz
Damping Factor @ 2 Ω: >60 / 50 Hz
THD+N @ Rated Power: <1% @ 2 Ω per Ch.
Input Voltage Range @ RCA Inputs: 200 mV - 4 V RMS
Min.Copper Power / Ground Wire Gauge: 8 AWG wire
Fuse Rating: 30 A (AFS, AGU or MaxiFuse)

Signal Processing
Filter Mode(s): Low-Pass only
Filter Slope(s): 12/24 dB/octave
Filter Frequency Range: 50 Hz - 500 Hz
Detented, Calibrated Filter Freq. Potentiometer: Yes
Filter Defeat Function: Yes
Infrasonic Filter: none
Bass Boost EQ: No
Output Polarity Switch: No
Remote Subwoofer Level Control: Optional HD-RLC or MHD-RLC (water-resistant)
Remote Bass EQ Boost Control: No
Pass-Through Preamp Output: Buffered