Compact and Versatile: Fits nearly anywhere: 9.50 x 7.50 x 2.10 in. (242 x 190 x 53 mm) Ultra-flexible outputs, capable of multiple configurations:4-Ch. Satellite Amp: power front and rear speakers with 75W x 43-Ch. System Amp: power front speakers with 75W x 2 and a sub with up to 200W2-Ch. High-Power Satellite Amp: power 2pr. of speakers with 200W x 22-Ch. High-Power Subwoofer Amp: drive two subwoofers with 200W x 2

NexD™ Switching Amplifier Technology: Our advanced high-speed switching technology delivers outstanding fidelity with very low noise and distortion. Exceptional efficiency results in reduced current draw and heat, permitting reliable high power output within a very small chassis. Full-bandwidth operation in all channels. (20 Hz - 20 kHz bandwidth)

Complete Signal Processing Sections: 12dB/octave high or low-pass filters for each channel pair, defeatable, with fully variable frequency selection from 50-500 Hz. Preamp outputs (buffered, pass-through type, from CH. 1&2)

Dual-Range, Differential-Balanced Inputs and Automatic Turn-On Capabilities: NO NOISE! Outstanding noise rejection prevents alternator whine and other noises. Accepts line-level or speaker level signals up to 8V RMS, including those from factory systems, without a line-output converter (LOC): just splice wires to a pair of RCA ends or RCA cables. Selectable Input Mode switch permits one pair of inputs to feed both pairs of output channels. Automatic turn-on option via Signal-Sensing or DC-Offset sensing

Integrated LED Clipping Indicators for Easy Setup: Simplifies input-sensitivity setting by providing accurate visual feedback of output clipping level.1) Disconnect one speaker output wire2) Play full-scale (0 dBfs) sine-wave through audio system, with head unit at 3/4 volume and tone controls set flat.3) Adjust input sensitivity until light turns on, then back off slightly. Separate, top-mounted LEDs report overall status and condition

C1 speakers deliver real substance and great audio performance in a format designed for easy fit behind factory grilles. To facilitate fit, breakaway mounting tabs on the woofer frame allow the C1-400x to be installed in four-hole or two-hole mounting configurations.

C1 woofer drivers benefit from proprietary FEA modeling and JL Audio's expertise in low-frequency driver design. This knowledge is used to create speakers that can play loudly, while maintaining a smooth, dynamic, low distortion sound. At the core of the C1-400x is a proprietary, stamped, steel 4-inch (100 mm) frame and a DMA-optimized motor system. A mineral-filled, injection-molded polypropylene cone is suspended with a rubber surround on the front, and a carefully engineered spider at the top of the voice coil, to precisely control motion and prevent impact between the voice coil and the back plate. Tinsel leads are carefully routed and attached to the spider to prevent fatigue and buzzing. These are the same kinds of features and materials normally found on much more expensive loudspeakers.

Equipped with a true, edge-driven, aluminum dome tweeter, C1 speakers stand further apart from others in its category with superior high-frequency clarity and definition. The tweeter’s design has inherently excellent off-axis response and high-frequency extension. It also benefits from the damping of a silk surround suspension and Ferrofluid in the voice coil gap, along with the superior strength of a neodymium magnet circuit. A true, 2nd order high-pass filter is employed to further enhance smoothness and improve power handling.

Sold as a pair. Grilles not included.