Description
The Club A754 4-channel amplifier delivers a powerful 75-Watts RMS to each of the front, and rear speakers in your car. You can also bridge the amp to 2-channel mode to drive, a couple subs with 200 watts RMS or 3-channel mode to drive both a pair of full range, speakers and a subwoofer. Speaker-level inputs allow this amplifier to integrate into almost, any system, even one using your car’s factory radio. Separate high-pass and low-pass, crossovers on the front and rear channels allow you dial in the perfect roll off to best suit, speaker placement and cabin acoustics.
What’s in the box:
One Club A754 four channel amplifier
4 Bare wire-to-RCA adapters
Four 30A ATO fuses (2 installed, 2 spare)
Two JBL stickers
Owner’s Manual
4 Mounting screws (M4 x 53mm)
1 logo badage
Technical specifications:
4 channel car amplifier
75 watts RMS x 4 at 4 ohms (100 watts RMS x 4 at 2 ohms)
200 watts RMS x 2 at 4 ohms in bridged mode (4-ohm stable in bridged mode)
Variable high- and low-pass filters (32–320Hz, 12dB/octave) on front and rear channels
Preamp and speaker-level inputs
Preamp outputs
Fuse rating: 30A x 2
8-gauge power and ground leads recommended – wiring and hardware not included with amplifier
W x H x D = 320mm x 51.3mm x 180mm
W x H x D = 12-5/8" x 2-1/16" x 7-1/8"
What’s in the box:
One Club A754 four channel amplifier
4 Bare wire-to-RCA adapters
Four 30A ATO fuses (2 installed, 2 spare)
Two JBL stickers
Owner’s Manual
4 Mounting screws (M4 x 53mm)
1 logo badage
Technical specifications:
4 channel car amplifier
75 watts RMS x 4 at 4 ohms (100 watts RMS x 4 at 2 ohms)
200 watts RMS x 2 at 4 ohms in bridged mode (4-ohm stable in bridged mode)
Variable high- and low-pass filters (32–320Hz, 12dB/octave) on front and rear channels
Preamp and speaker-level inputs
Preamp outputs
Fuse rating: 30A x 2
8-gauge power and ground leads recommended – wiring and hardware not included with amplifier
W x H x D = 320mm x 51.3mm x 180mm
W x H x D = 12-5/8" x 2-1/16" x 7-1/8"