Description
Included in this kit
This bundle includes a JL Audio RD800/6 6-channel full-range amplifier 800 watts, a SSV Works BR-B65U Unloaded 6.5" Rear Speaker-Pod Add Ons, 2x JL Audio C2-400x:4-inch (100 mm) Coaxial Speaker System (Pair), and 2x JL Audio C2-650x:6.5-inch (165 mm) Coaxial Speaker System (Pair).
1x JL Audio RD800/6 6-channel full-range amplifier 800 watts - (RD800/6)
SLEEK, POWERFUL, PACKED WITH VALUE
The look is amazing, and the performance backs it up. These ultracompact full-range RD series amplifiers from JL Audio are engineered to generate loads of power with exceptional efficiency and low distortion. The result: premium audio quality with significantly reduced current draw and heat.
General
Channels: 6
Physical dimensions (Height): 2.13" (54 mm)
Physical dimensions (Width): 14.66" (372 mm)
Physical dimensions (Depth): 6.96" (177 mm)
Weight: 7.15 lbs (3.6 kg)
Operating voltage: 10-15 VDC
Operating temperature range: –4º to 149º F (–20º to 65º C)
Warranty: 2 years
Audio
Amplifier class: Class D
Rated continuous (RMS) power (14.4 V input @ 4 Ohm < 1% THD): 75 W x 4/150 x 2 200 W x 2/400 W x 1 (Bridged)
Rated continuous (RMS) power (14.4 V input @ 2 Ohm < 1% THD): 100 W x 4/200 x 2
Signal-to-Noise Ratio, referred to highest rated power (A-weighted, 20 Hz - 20 kHz noise bandwidth): Analog Inputs >104 dB
Signal-to-Noise Ratio, referred to 1 W (A-weighted, 20 Hz - 20 kHz noise bandwidth): Analog Inputs >84 dB
Damping factor @ 4 Ω: >150/50 Hz
Damping factor @ 2 Ω: >75/50 Hz
THD+N @ Rated Power: <1% @ 4 Ω
Frequency response (+0, -1dB): 12 Hz-22 kHz
Input voltage range @ RCA inputs: Switchable from 200 mV-2 V RMS (Low) to 800 mV-8 V RMS (High)
Signal Processing
Filter mode(s): Channels 1 & 2: High-pass only (Off, x1, x10)
Filter Slope(s): Channels 1 & 2 12 dB/octave
Filter frequency range: Channels 1 & 2: 50 Hz-500 Hz (x10: 500 Hz-5 kHz)
Filter mode(s): Channels 3 & 4: Off, High-pass or Bandpass
Filter Slope(s): Channels 3 & 4 12 dB/octave
Filter frequency range: Channels 3 & 4 50 Hz-500 Hz
Filter mode(s): Channels 5 & 6: Off, High-pass or Bandpass
Filter Slope(s): Channels 5 & 6: 12 dB/octave
Filter frequency range: Channels 5 & 6: 50 Hz-500 Hz
Detented, calibrated filter frequent potentiometers: Yes
Channel input mode switch: yes (2/4/6 Channels)
Pass-through preamp output: Buffered
1x SSV Works BR-B65U Unloaded 6.5" Rear Speaker-Pod Add Ons - (BR-B65U)
The Bronco comes with a small, cheap speaker in the rear attached to the factory roll-cage. The SSV Works Rear Speaker-Pod upgrade allows you replace those factory speakers with a set of larger, more powerful 6.5" weatherproof speakers.
Plug-&-Pay: By replacing the factory speakers, we utilize the factory harnessing. You know what that means right? Of course, SSV Works Bronco Speaker-Pods are a full plug-&-play installation on both standard and B&O factory systems.
These pods are injection molded out of ASA plastic for maximum strength and ability to withstand extreme hot and cold temperatures. Metal support plates are made of 2mm powder coated mild steel and add additional mounting points that help make installing the speaker converts a breeze.
As of right now, the pods only fit the 4 seater model. The roll cage for the Bronco is slightly different on 2 seater. The SSV Works engineering team is looking into what needs to be done to make these work on a 2 seater as well.
Compatible with:
Select 2021+ Bronco 4-Door vehicles
Base, Big Bend, Black Diamond, Outer Banks, Badlands, Wildtrak, Everglades
Dimensions:
Cutout Diameter: 5.589"
Mounting Depth: 3.755"
Maximum Frame/Grille Diameter: 6.915"
4 Hole Bolt Pattern: 4.161" (horizontally & vertically), 5.967" (diagonally)
3 Hole Bolt Pattern: 5.138" (horizontally & vertically)
2x JL Audio C2-400x:4-inch (100 mm) Coaxial Speaker System (Pair) - (C2-400x)
JL Audio C2-400x
Coaxial Speaker System: 4-inch (100 mm) Woofer, 0.75-inch (19 mm) Silk Dome Tweeter
The Evolution C2 systems deliver sparkling high-frequency detail, smooth mid-range and powerful mid-bass, thanks to real silk dome tweeters and precision-engineered woofer designs.
The C2-400x system features 4-inch (100 mm) woofers with mineral-filled polypropylene cones, long excursion capabilities and stamped steel frames. The woofer design benefits from JL Audio's vast woofer design experience and advanced modeling systems.
Breakaway mounting tabs on the woofer frame allow the C2-400x to be installed in four-hole or two-hole configurations. Injection-Molded adaptor plates are also included to allow mounting of the C2-400x speakers into a 4 x 6 (100 x 150 mm) speaker location.
Tweeters are coaxially mounted and built with 0.75-inch silk dome diaphragms that deliver smooth, extended response, on and off axis. The small size of the C2 tweeter minimizes tweeter protrusion, allowing C2 coaxials to fit behind most factory speaker grilles.
Sold as a pair.
General Specifications
| Continuous Power Handling (RMS) | 35 W |
| Peak Music Power | 105 W |
| Recommended Amplifier Power (RMS) | 10 - 50 W / Ch. |
| System Efficiency | 84.5 dB @ 1 W / 1 m |
| System Nominal Impedance | 4 Ω |
| System Frequency Response | 71 Hz - 22 KHz ± 3 dB |
Coaxial Physical Specifications
| Frame Outer Diameter* (A) | 4.02 in / 102 mm |
| Grille Tray Outer Diameter (B) | 5.20 in / 132 mm |
| Motor Outer Diameter (C) | 2.36 in / 60 mm |
| Frontal Coaxial Tweeter Protrusion** (D) | 0.56 in / 14 mm |
| Frontal Grille Protrusion*** (E) | 0.66 in / 17 mm |
| Mounting Hole Diameter (F) | 3.81 in / 97 mm |
| Mounting Depth (G) | 1.81 in / 46 mm |
2x JL Audio C2-650x:6.5-inch (165 mm) Coaxial Speaker System (Pair) - (C2-650x)
JL Audio C2-650x
Coaxial Speaker System: 6.5-inch (165 mm) Woofer, 0.75-inch (19 mm) Silk Dome Tweeter
The Evolution C2 systems deliver sparkling high-frequency detail, smooth mid-range and powerful mid-bass, thanks to real silk dome tweeters and precision-engineered woofer designs.
The C2-650x system features 6.5-inch (165 mm) woofers with mineral-filled polypropylene cones, long excursion capabilities and stamped steel frames. The woofer design benefits from JL Audio's vast woofer design experience and advanced modeling systems.
The 6.5-inch (165 mm) format is a direct fit in many vehicles. Multiple mounting patterns are provided on the woofer frame for easy installation into most vehicles that accept a 6.5-inch (165 mm) speaker.
Tweeters are coaxially mounted and built with 0.75-inch silk dome diaphragms that deliver smooth, extended response, on and off axis. The small size of the C2 tweeter minimizes tweeter protrusion, allowing C2 coaxials to fit behind most factory speaker grilles.
Sold as a pair.
General Specifications
| Continuous Power Handling (RMS) | 60 W |
| Peak Music Power | 225 W |
| Recommended Amplifier Power (RMS) | 15 - 100 W / Ch. |
| System Efficiency | 91 dB @ 1 W / 1 m |
| System Nominal Impedance | 4 Ω |
| System Frequency Response | 59 Hz - 22 KHz ± 3 dB |
Coaxial Physical Specifications
| Frame Outer Diameter* (A) | 6.5 in / 165 mm |
| Grille Tray Outer Diameter (B) | 6.84 in / 174 mm |
| Motor Outer Diameter (C) | 3.15 in / 80 mm |
| Frontal Coaxial Tweeter Protrusion** (D) | 0.45 in / 12 mm |
| Frontal Grille Protrusion*** (E) | 0.85 in / 22 mm |
| Mounting Hole Diameter (F) | 5.56 in / 141 mm |
| Mounting Depth (G) | 2.44 in / 62 mm |