Description
Included in this kit
This bundle includes a Kicker 46CXA6605 CXA6605 - 4x90-Watt 4-Channel Full-Range Amp w/300-watt Class D Sub Channel, and 2x Kicker 52CVT124 CVT12 CompVT 12-Inch (30cm) Subwoofer, 4 Ohm SVC.
1x Kicker 46CXA6605 CXA6605 - 4x90-Watt 4-Channel Full-Range Amp w/300-watt Class D Sub Channel - (46CXA6605)
Kicker 46CXA6605 CX660.5 660 Watt RMS 2-Ohm Stable 5-Channel Amplifier
Using Class A/B power, this amp features a variable bass boost with KickEQ™, giving you as much as a 6dB of extra bump.
CX-Series Amplifiers accept up to 40 volts (400 watts) of speaker-level input signal. This kind of flexibility both makes line-out converters unnecessary and optimizes your sound quality.
This CX amplifier delivers as much as 90 watts into four full-range channels or 180 watts into two-bridged channels, plus as much as 300 watts into one bass channel. See below for more details.
Features:
• Class A/B full-range channels
• Class D bass channel included for one amp to run an entire system
• Three-second turn-on/off delay to eliminate unwanted interference
• Variable 12dB crossovers provides control to dial in perfect sound
• KickEQ™ 6dB variable bass boost for those additional low frequencies
• 24dB subsonic filter for protection from potentially damaging frequencies
• FIT+™ (Fail-safe Integration Technology-PLUS) means it works with nearly every radio
• Accepts up to 40-volt input signal
• Small footprint for easier installation
• Vertical mounting hardware included for another unique look
Specifications:
• MODEL - CXA660.5
• Power (watts/ch) 4 Ohm Stereo - 65x4
• Power (watts/ch) 2 Ohm Stereo - 90x4
• Power (watts/ch) 4 Ohm Mono - 180x2
• Power (watts/ch) 4 Ohm Mono Sub Ch - 150x1
• Power (watts/ch) 2 Ohm Mono Sub Ch - 300x1
• CXRC Remote Bass Capable (sold sep.) - yes
• Dimensions (in, cm): (all models 2-3/8, 5.9H x 6-3/4, 17 W x ...L) - 14-1/8, 35.7
• Frequency Response (Hz): - 10Hz-20kHz
• Frequency Response (Hz – Sub Ch.): - 25Hz-200Hz
• Input Sensitivity: - 250mV-10V (Low Level), 1V-40V (High Level)
• Signal-to-Noise Ratio: - 90dB
• Active Crossover: - Amp 1-2: High Pass 10-200Hz @ 12dB/Octave, Sub Channel: Low Pass 50-200Hz @ 12dB/Octave
• Subsonic Filter: - 25Hz @24dB/Octave
• KickEQ™ Boost - Variable 0-6dB @40Hz
2x Kicker 52CVT124 CVT12 CompVT 12-Inch (30cm) Subwoofer, 4 Ohm SVC - (52CVT124)
The CompVT 12-Inch Subwoofer is available as a 4Ω slimline driver.
New and improved, precise KICKER engineering allows the CompVT to pound with limited space. A proprietary four-layer voice coil collaborating with SoloKon™ cone technology, provides the ability to work with serious amounts of power without the bulk of a standard subwoofer.
The CompVT Subwoofer works best with a sealed or ported enclosure for its substantial power handling.
Specifications
SIZE [in, cm]: 12, 30
IMPEDANCE [Ohms]: 4 SVC
Recommended Amplifier Power (watts RMS) 225-450
Peak Power (watts, per ANSI/CTA-2031-A) 900
SENSITIVITY [dB 1w/1m]: 87.1
MOUNTING DEPTH [in, cm]: 4-3/8, 11.1
MOUNTING DIAMETER [in, cm]: 11, 28.1
MIN SEALED BOX VOL [cu. ft, L]: 1, 27.9
MAX SEALED BOX VOL [cu. ft, L]: 4.6, 130
MIN VENTED BOX VOL [cu. ft, L]: 1.75, 49.6
MAX VENTED BOX VOL [cu. ft, L]: 2.25, 63.7
Thiele/Small Parameters
Re: 3.695 Ohm
Krm: 0.0024 Ohm
Erm: 0.965
Kxm: 0.02685 Ohm
Exm: 0.78
Cmes: 1103.91
Lces: 17.435
Res: 30.83 Ohm
fs: 36.35 Hz
Mms: 184.6795 g
Mmd (Sd): 170.8555 g
Rms: 5.427 kg/s
Cms: 0.104 mm/N
Kms: 9.63 N/mm
Bl: 12.934 Tm
Qtp: 0.9215 total Q-factor considering all losses
Qms: 7.7675 mechanical Q-factor of driver in free air considering Rms only
Qes: 0.93 electrical Q-factor of driver in free air considering Re only
Qts: 0.831 total Q-factor considering Re and Rms only
Vas: 41.59095 I
n0: 0.2055 reference efficiency (2 pi-radiation using Re)
Lm: 85.33 dB characteristic sound pressure level (SPL at 1m for 1W @ Re)
Lnom: 85.675 dB nominal sensitivity (SPL at 1m for 1W @ Zn)
Sd: 530.93 cm² diaphragm area
Xmax: 13 mm