Description
Included in this kit
This bundle includes a JL Audio AP200/4BT - 4-Channel Compact 200-Watt Marine Amplifier with Built-In Bluetooth, a JL Audio M200 6.5" Marine Coaxial Speakers with White Sport Grilles with RGB LED Lighting - 010-04753-02, and a JL Audio MLC-RW Marine LED Lighting Controller with WiFi.
1x JL Audio AP200/4BT - 4-Channel Compact 200-Watt Marine Amplifier with Built-In Bluetooth (AP200/4BT)
JL Audio AP2004/BT – Compact 4-Channel Marine Amplifier with Bluetooth® Streaming
The JL Audio AP2004/BT is a compact 4-channel Class-D amplifier with integrated Bluetooth® audio designed for small boats, PWCs, and overland vehicles. It combines efficient full-range power, marine-rated durability, and simple wireless control in a small footprint that is easy to mount in tight spaces.
Compact Class-D Power with Bluetooth® Audio
The AP2004/BT uses efficient Class-D amplifier technology to provide clean power with lower current draw than traditional Class-AB designs. It is designed to run from a 9–16 VDC electrical system and is well suited for smaller boats, jet skis, and powersports/overland applications where available power and space are limited.
Rated at 40 watts x 4 into 4 ohms or 50 watts x 4 into 2 ohms (14.4 V, <1% THD), the amplifier can also be bridged to deliver 100 watts x 2 at 4 ohms. This provides enough output for full-range speakers and small subwoofer channels within a single, compact chassis.
- 4-channel Class-D design for efficient, full-range output with reduced battery load.
- Bluetooth® audio built-in, so a separate head unit is not required for basic systems.
- Rated continuous power of 40 W x 4 @ 4 Ω or 50 W x 4 @ 2 Ω; 100 W x 2 @ 4 Ω bridged.
- 20 Hz–20 kHz frequency response (+0, -1 dB) for full-range music reproduction.
- THD+N <1% at rated 4-ohm power with signal-to-noise ratio >70 dB (A-weighted, 1 W).
Bluetooth® Control and Marine-Ready Construction
The AP2004/BT pairs directly with a compatible smartphone or tablet for wireless audio streaming. An IPX7-rated wired remote is included and can be flush-mounted, surface-mounted, or bar-mounted, allowing you to control playback and volume from a convenient location on your boat or vehicle.
The amplifier chassis is built to IP67 water and dust standards (excluding cables) and is ignition protected, making it suitable for harsh marine environments and engine compartments when installed correctly. Its compact size allows flexible mounting options without taking up valuable storage or cockpit space.
- IP67-rated amplifier chassis for water and dust resistance in marine applications.
- Ignition protected design for safe installation in appropriate engine compartment locations.
- IPX7-rated wired remote with multiple mounting options (flush, surface, or bar).
- Operating temperature range from 4° to 149°F (-20° to 65°C) for real-world outdoor use.
- Very low standby current draw (<1 mA) and idle current consumption under 700–750 mA.
| Part Number | 010-03431-00 |
| Amplifier Class | Class D |
| Channels | 4-channel |
| Rated Power @ 4 Ω (14.4 V) | 40 W x 4 / 100 W x 2 bridged (<1% THD) |
| Rated Power @ 2 Ω (14.4 V) | 50 W x 4 (<1% THD) |
| Frequency Response | 20 Hz – 20 kHz (+0, -1 dB) |
| Signal-to-Noise Ratio | >70 dB (A-weighted, 20 Hz–20 kHz, referred to 1 W) |
| THD+N @ Rated Power | <1% @ 4 Ω per channel |
| Input Type | RCA inputs with switchable sensitivity range |
| Input Voltage Range | Low: 200 mV–2 V RMS, High: 800 mV–8 V RMS |
| Input Impedance | 11 kΩ (High), 20 kΩ (Low) |
| Operating Voltage | 9–16 VDC |
| Water/Dust Rating | IP67 (amplifier, excluding cables) |
| Amplifier Dimensions (H x W x D) | 1.85" x 7.28" x 4.90" (47 x 185 x 125 mm) |
| Standby Current | <1 mA |
| Idle Current | <700–750 mA |
| Fuse Rating | 35 A (AFS, AGU, or MaxiFuse™ recommended) |
| Minimum Power/Ground Wire | 4 AWG copper wire |
| Protection Circuits | Input under/over voltage, over-temperature, output short circuit |
| Operating Temperature | 4° to 149°F (-20° to 65°C) |
| Warranty | 3 years |
- JL Audio AP2004/BT 4-channel amplifier with Bluetooth® technology
- Wired remote controller
- Surface mounting cup for remote with four mounting screws
- Four amplifier mounting screws
- Flush mounting kit for remote controller
- Flush mounting template for remote controller
- Waterproof gasket for remote controller
- Documentation and installation information
1x JL Audio M200 6.5" Marine Coaxial Speakers with White Sport Grilles with RGB LED Lighting - 010-04753-02 (M200-650x-S-Gw-i)
JL Audio M200 6.5" Marine Coaxial Speakers with White Sport Grilles with RGB LED Lighting
This JL Audio M200 6.5-inch coaxial speaker variant combines a marine-grade woofer and bridge-mounted silk-dome tweeter behind white sport grilles. Its 50-watt RMS rating, 55 Hz–20 kHz response and integrated RGB lighting make it a focused fit for open-air marine listening.
On-Water Advantages
Purpose-Built Features
- Coaxial architecture places the tweeter over the woofer for a compact full-range installation.
- The neodymium tweeter motor and ferrofluid cooling support clear high-frequency output.
- Corrosion-resistant construction is tested against salt, sun and changing marine conditions.
- RGB illumination adds color to the listening area.
| Speaker Type | 6.5" marine coaxial |
| Grille | White Sport Grilles |
| RGB Lighting | RGB; 10–14.4 VDC; 140 mA maximum |
| RMS Power | 50 W |
| Recommended Amplifier Power | 30–100 W per channel |
| Sensitivity | 87 dB |
| Frequency Response | 55 Hz–20 kHz |
| Impedance | 4 ohms |
| Tweeter | 1" edge-driven silk dome |
| Cone | Injection-molded, mica-filled polypropylene |
| Water Rating | IPX6 |
| Overall Dimensions | 6.90" diameter x 4.19" depth |
| Mounting Depth | 2.83" |
| Cutout Diameter | 5.00–5.25" |
| Warranty | 3 years |
1x JL Audio MLC-RW Marine LED Lighting Controller with WiFi (MLC-RW)
The JL Audio MLC-RW features a compact, mount-anywhere form factor and an easy-to-use, rotary knob for adjusting the speakers' illumination color and intensity. This RGB controller works seamlessly with M6 series speakers, as well as most other RGB lighting options installed on a boat. State-of-the-art management of RGB LED lighting circuits, with advanced smartphone connectivity and safety features.
• PWM technology delivers up to 30A (400 W) of continuous output to power large, multi-LED installations.
• Will drive the LED’s of up to sixty JL Audio marine speakers, with appropriate wiring.
• Rotary encoder delivers comprehensive control using a single knob.
• Versatile knob design easily mounts to flat panels or under a dashboard using the included adaptor bracket.
• LED control modes include “Color Spectrum”, to choose a specific lighting color, and ”Brightness” to adjust the lighting intensity.
• A “Color Cycle” mode can also be engaged to continually change the color spectrum, which is very useful for demonstrations.
• Built-In WiFi network (B/G/N) provides robust connectivity with your compatible iOS® or Android® device.
• Easily manage all LED functions via your smartphone, using the LiteWave ITI iOS or Android app. (Note: LiteWave ITI is third party software available for download on the App Store and Google Play.)
• Automatic over-current and short-circuit protection will shut down the lighting when a fault is detected.
• Voltage and temperature monitoring