Description
The Club A5055 5-channel amplifier delivers a powerful 50-Watts RMS to each of the front and rear speakers in your car, and a pounding 500-Watts RMS to the subwoofer channel — a much smarter ratio of subwoofer-to-full-range power than what is typical in 5-channel amps. You can also bridge the amp to 3-channel mode to deliver 140-Watts RMS to your front speakers while driving your sub with 500-Watts RMS. Speaker-level inputs allow this amplifier to integrate into almost any system, even one using your car’s factory radio. Separate high-pass and low-pass crossovers on the front and rear channels allow you dial in the perfect roll off to best suit speaker placement and cabin acoustics. The subwoofer channel features a low-pass crossover, selectable bass boost, and phase switch to optimize subwoofer performance.
What’s in the box:
One Club A5055 five channel amplifier
4 Bare wire-to-RCA adapters
Six 30A ATO fuses (3 installed, 3 spare)
Remote bass control module
16.5’ Remote control cable (RJ-25 plugs on
both ends)
2 Self-tapping screws for remote (M3 x 15mm)
4 Mounting screws (M4 x 53mm)
Owner’s Manual
Two JBL stickers
1 logo badage
Technical specifications:
5 channel car amplifier
50 watts RMS x 4 + 320 watts RMS x 1 at 4 ohms
75 watts RMS x 4 + 500 watts RMS x 1 at 2 ohms
150 watts RMS x 2 bridged at 4 ohms + 500 watts RMS x 1 at 2 ohms
Variable high- and low-pass filters (32–320Hz, 12dB/octave) on front and rear channels
Low-pass filter (32–320Hz, 12dB/octave) on subwoofer channel
Bass boost on subwoofer channel (0-12dB at 45Hz)
Phase switch on subwoofer channel (0, 180 degrees)
Preamp and speaker-level inputs
Fuse rating: 30A x 3
4-gauge power and ground leads recommended — wiring and hardware not included with amplifier
W x H x D = 360mm x 51.3mm x 180mm
W x H x D = 14-3/16" x 2-1/16" x 7-1/8"
